Bienvenue
Veuillez confirmer vos préférences
Mettre à jour les préférences
Suggestions de produit
Product Family suggestions
Kennametal à votre service
Support Clients
Nouveau client
Êtes-vous un nouveau client de Kennametal ? Créez un compte et commencez.
Créer un compteBonjour, User Name
Votre compte sélectionné :
Il y a un problème avec votre compte. Veuillez contacter le service client.
Compte Client
Modifier le compte
Compte de livraison
Modifier le compte
- Tableau de bord
- Gérer les commandes
- Gérer les canaux
- Carnet d’adresses
-
Notifications
Mark all as read - Modifier le mot de passe
- Mon profil
- Se déconnecter
Article(s)
ajoutées avec succès au panier
Voir le panier
Voir le panier
- Ressources
- /
- Conseils Techniques
- /
- Conseils techniques : Perçage
- /
- Tech Tip #8 - Reamer Guidelines
Tech Tip #8 - Reamer Guidelines
Kennametal can recommend a drill size that will leave an appropriate amount of material for the reamer to efficiently size the finished hole.
General guidelines for drill sizes are:
- <1/4” = .010”
- ¼” to ½” = .015”
- ½” to 1-1/2” = .025”
A common misconception is to leave too little material for the reamer to remove. The reamer needs enough material to make its cut. Too little material will cause the reamer to rub or burnish and results in accelerated wear and poor surface finish.
Cutting speeds should be about two-thirds that of drilling SFM for similar material and feeds should be two to three times higher.