Mill 4

header_en

STEPLESS SOLUTIONS

A challenge with step down applications is, that most tools leave tool marks with every pass they take. Resulting in unsatisfactory or low quality wall finishes, requiring another finishing pass at the very end of the process.

Applying Mill 4™ delivers pristine wall finishes, and eliminates that finishing pass with an additional tool. That saves you time, and reduces your production cost.

 

SGE-GEOMETRY

  • SGE is the universal geometry for Mill 4-11™. First choice when machining steel, as well as stainless steel, and high-temp alloys in heavy applications.
  • Precision ground insert results in a great compromise for both roughing and finishing operations. Honed and negativ T-Land for strongest cutting edge.

EGE-Geometry

  • EGE is the first choice for stainless steel and high-temp alloys.
  • Use EGE-geometry for the highest finishing requirements in light machining for all materials. Honed for free cutting action.

SGEM-Geometry

  • First choice for cast iron applications, applicable in steel as well.
  • Precision ground insert with very strong cutting edge for roughing applications.
  • For heavy machining applications.

EGEJ-Geometry

  • Mill 4-15™ geometry for aluminum and other non ferrous materials.
  • Precision ground, sharp cutting edge for semi finishing to finishing applications.
  • For light to heavy machining applications.

ELEJ-Geometry

  • Mill 4-11™ geometry for aluminum and other non ferrous materials.
  • Precision ground insert with a sharp cutting edge for semi finishing to finishing applications.
  • For light to heavy machining applications.

GET A FREE MILL 4™ MILLING CUTTER IN 3 SIMPLE STEPS*

1. STEP

2. STEP

3. STEP

CALL TODAY AND REFER TO PROMO CODE BUY10GET1-MILL4
+1 800.446.7738

*OFFER ENDS SEPTEMBER 30, 2017. OFFER VOID WHERE PROHIBITED BY LAW. ALSO AVAILABLE THROUGH PARTICIPATING DISTRIBUTORS.

 

With NOVO™, tool selection is done in a few minutes, instead of hours.

kennametal.com/NOVO