No Items in Cart
Sign In
Loading Profile
Polski

Moment i moc dla frezów trzpieniowych KM

Dla frezów trzpieniowych z płytkami wymiennymi z narzędziami szybkowymiennymi KM

Conversion of Workpiece Material Rockwell (Optional)

Skip this step if you already know the Brinell hardness number(HB)
 

Characteristics of Workpiece Materials

HB
PSI N/mm 2
 

End Mill Nomenclature

in. mm.
in. mm.
in. mm.

Machining Conditions

sfm m/min
in.(DOC) mm (DOC)
in.(WOC) mm(WOC)
in. IPT (chip load) mm
   
Most Common Workpiece Materials Cm at W/D ratios:
W/D < = 0.66 0.66 < W/D < 1.0 W/D = 1.0
Aluminum alloys 1.0 1.05 1.1
Carbon and alloy steels 1.0 1.15 1.3
Cast irons 1.0 1.15 1.3
Titanium alloys 1.0 1.20 1.4
Stainless steel, High-temperature alloys 2.0 2.15 2.3
   
Milling Depth of cut Feed per tooth Cw
Category (min-max), in. (min-max), in. &nbsp;
Light 0.020-0.100 0.003-0.006 1.1
Medium 0.100-0.200 0.006-0.010 1.2
Heavy duty 0.200-0.400 0.010-0.020 1.3
   
Direct Belt Drive .9
Back Gear Drive .75
Geared Head Drive .7-.8
Oil - Hydraulic Drive .6-.9
 
 

Safe Operating Conditions

lb N
lb N
ft lb Nm
ft lb Nm

Calculated Machining Conditions

RPM
(IPM)(no productivity formula) mm/min
in (chip load at the cut) mm/min
(IPM)(with productivity formula) mm/min
in.3/min MRR cm3/min3
in.2 mm2

Calculated Required Power

lbf should not exceed Ft max N
ft-lb should not exceed Tp Nm

Machining Power

HPc kW
hp kW

These calculations are based upon theoretical values and are only intended for planning purposes. Actual results will vary. No responsibility from Kennametal is assumed.