successfully added to cart
View Cart


Mark all as read

Metallurgical Expert Knowledge on Aluminum:

While pure aluminum has low specific gravity, good corrosion resistance, excellent thermal conductivity, and electrical conductivity, it is too weak and ductile to be used on its own. The most commonly used aluminum alloys for airframe construction are the 2000 and 7000 series.

2000 series aluminum alloys

Contains 1,9-6,8% copper content and often contains additions of manganese, magnesium and zinc. They are used for forgings, extrusions and liquified gas storage tanks in civil transport and supersonic aircraft. These alloys have lower crack growth rates and thus have better fatigue performance than the 7000 series alloys. Therefore, these are used on the lower wings and body skin.

Commonly used 2000 series alloys are 2224, 2324, 2524.

These alloys are often cladded with 99,34% pure aluminum for increased corrosion resistance.

7000 series aluminum alloys

The Al-Zn-Mg system offers the greatest potential for precipitation hardening though copper is often added to improve stress corrosion cracking resistance (with the drawback of reducing weldability). Stress corrosion cracking resistance decreases with increasing Zn:Mg ratio.

Aluminum Lithium

Commercial aluminum-lithium alloys are characterized by their low density, high specific modulus, excellent fatigue, and cryogenic toughness properties.

The marriage of Li and Al reduces density by 3% and increases the elastic modulus by about 6%.

In contrast to new materials systems such as fiber-reinforced composites, low density aluminum alloys do not require large capital investments by the producer in new fabricating facilities.

Trends in the industry

"The use of aluminum in aerospace represent more than 50% of all the material consumed and remain relative constant overtime."

The next generation aircrafts are called hybrid-designs when fiber-reinforced materials are associated to new economic aluminum structures.


Aluminum part machining requires short takt time. Productivity is being measured as material removed in liters per minute.

Due to the relatively soft material properties, the material is being machined on high horse power machines (75-150kw) with spindle speeds up to 33,000 RPM.


  • Tool geometry to absorb the available machine power and convert to very high metal removal rate, avoiding build up edge and tool breakage at the same time.
  • High quality tool balancing.
  • Coolant design optimized for high speed machining.

Tooling Solutions

Modular End Mills



Hydraulic Chucks



5 Flute

Aluminum Rougher

KOR™ 5
Please adjust the following properties from

ISO Catalog Number

ANSI Catalog Number

to find similar products.
If you create a new solution, you will lose any solutions you were working on already. How would you like to proceed?
You are about to create a duplicate . Do you want to proceed?
You are about to delete Do you want to proceed?
What would you like to rename your to?
Please enter a valid name
Please enter a name for the duplicate
Please enter a valid name
You are about to add to your My Solutions page. Do you want to proceed?
Please enter a valid name
Send a copy of

Please enter a valid Email
Please enter a valid name

We have found the following CAD Drawings

Select the files you are looking for and download them all at once

You should be logged to see your dashboard information
The product/s () you were trying to add to the cart is/are not available, please contact customer service.
item(s) successfully added to the cart
View Cart