Tech Tip #129 - Using Hydraulic Chucks – Kennametal

  1. Remove all grease from the hydraulic chuck and cutting tools before using.
  2. Insert the cutting tool into the clamping bore as far as the stop pin /stop screw will allow.
  3. Adjust the cutting tool length with a hex wrench.
  4. Always hand-tighten the clamping screw with a hex wrench as far as the stop limit. Never try to adjust the stop pin when the hydraulic chuck is in the clamping position.
  5. For best accuracy, use a round shank (no flats) with h6 tolerance and no bushing.
  6. Weldon shanks can be gripped without reducer collets, ¾” (20 mm) maximum diameter. However, the use of reducer collets for all flatted shanks is recommended.
You are about to add to your My Solutions page. Do you want to proceed?
product-image
Please adjust the following properties from

ISO Catalog Number

ANSI Catalog Number

to find similar products.

The following files are available

Please select a file to download

Models

Product data

You should be logged to see your dashboard information
Session expired due to inactivity, please login again
The product/s () you were trying to add to the cart is/are not available, please contact customer service
item(s) successfully added to the cart
View Cart

. Please enter the desired qty for the material(s) you want to include in your promotion or Proceed Without Promotion and only your base materials will be added to the cart.

Minimum quantity should be

SAP Material NumberISO Catalog NumberGrade  

You are about to leave the Solution building process.

Are you sure you want to leave?