Zurück zur Lösung
Lösung bearbeiten
Lösung hinzufügen
Lösungsname: {{SolutionName}}Einstellwinkel und Auswahl der Auflageplatte, Unterlage
Berechnen Sie den Einstellwinkel und ermitteln Sie die Auflageplatte, Unterlage für das LT-Gewindedrehsystem.
These calculations are based upon theoretical values and are only intended for planning purposes. Actual results will vary. No responsibility from Kennametal is assumed.
Selection of SHIMs |
|
|---|
feed direction towards the chuck (standard helix )
To determine catalog number replace (*) asterisk with the number 3 or 4. (3 = 3/8 I.C. or 4 = 1/2 I.C.)
0° to 1° = SMYI*1N1° to 2° = SMYI*2° to 3° = SMYI*1P3° to 4° = SMYI*2P |
0° to 1° = SMYE*1N1° to 2° = SMYE*2° to 3° = SMYE*1P3° to 4° = SMYE*2P |
0° to 1° = SMYE*1N1° to 2° = SMYE*2° to 3° = SMYE*1P3° to 4° = SMYE*2P |
0° to 1° = SMYI*1N1° to 2° = SMYI*2° to 3° = SMYI*1P3° to 4° = SMYI*2P |
|---|---|---|---|
 |
 |
 |
 |
0° to -1° = SMYI*2N-1° to 2° = SMYI*3N |
0° to -1° = SMYE*2N-1° to 2° = SMYE*3N |
0° to -1° = SMYE*2N-1° to 2° = SMYE*3N |
0° to -1° = SMYI*2N-1° to 2° = SMYI*3N |
|---|---|---|---|
 |
 |
 |
 |