Tech Tip #68 - Plain Cylindrical Pin Gages

Go-No Go plain cylindrical gages are used to ensure plain holes are within tolerance. If the Go member is long enough to check the entire depth of the hole, it will be used to check hole straightness from top to bottom.

Special design “locating” gages can be used to check the position of holes. Plain gages are commonly used to check the minor diameter of tapped holes produced by a drill prior to tapping.

Plain cylindrical gages are available in four classes: “XX”, “X”, “Y”, and “Z”. “XX” gages are made to the tightest tolerance and used for master or setting gages, or for part tolerances that are very precise. “X” tolerance gages are sometimes used for master gages or gaging close work. “Y” and “Z” gages are generally used for inspecting workpieces only.

Selecting the right class of cylindrical gage is very important to ensure that “bad” parts are rejected and that “good” parts are not rejected. If a lower class gage is used on a tight tolerance part, the gage tolerance will consume most of the part tolerance and reject the part as “bad”. In this case, a “good” part might be rejected. Gage manufacturers call this “thievery” when gage tolerance “steals” part tolerance.

To ensure acceptance of the maximum number of good parts, select a gage class using the “5% rule”. That is, the gage tolerance should be no more than 5% of the part tolerance.

For example, if the part tolerance is 0.001”, the gage tolerance should be no more than 0.00005”. Select a class that has a 0.00005” tolerance or less.

See the Kennametal Gages catalog for gage standards charts for classes and tolerances. You will find the catalog by visiting www.kennametal.com, then going to the Products/Metalworking/Tapping section.

Vous êtes sur le point d’ajouter à votre page mes solutions. Souhaitez-vous continuer ?
product-image
Please adjust the following properties from

catalogue ISO

catalogue ANSI

to find similar products.

The following files are available

Please select a file to download

Models

Vous devez être connecté pour voir les informations de votre tableau de bord
Session expired due to inactivity, please login again
Le(s) produit(s) () que vous essayez d’ajouter au panier est/sont indisponible(s), veuillez Contacter le service client.
article(s) ajouté(s) avec succès au panier
View Cart

. Please enter the desired qty for the material(s) you want to include in your promotion or Proceed Without Promotion and only your base materials will be added to the cart.

Minimum quantity should be

SAP Material Number catalogue ISO Grade    
Thank you for your registration, pending approval & completion of the registration, your access is currently limited. Full utilization of product search capabilities & collaboration space is available and will remain. Please allow 2 business days for registration completion.

You are about to leave the Solution building process.

Are you sure you want to leave?